Ecco EW5430 Series Manual

The EW5430 range are an exciting new range of 4 LED Linear Driving Lamps with
'plug and play' wiring harnesses available to make fitting them to your vehicle a simple
operation.
Ranging from a 20W, 1,400 Lumen 161mm long lamp up to an 80W, 5,000 lumen
444mm long lamp, there's something to suit everyone's needs.
All the lamps are legal for use on European highways, approved to ECE Regulation 112
for use as a Driving Beam Headlight (Main Beam), and ECE Regulation 10 (EMC).
The lamps are supplied with full mounting hardware, the flying cable is terminated with a
fully environmentally sealed Deutsch 2 way connector and can be used with or without
the optional cable assemblies.
Cable assemblies are available separately for fitting either 2 or 4 lamps, they include the
environmentally sealed connectors, fuse holder and fuse, relay, switch and even have
cable sub-assemblies to tap into the vehicle main beam function if your vehicle is fitted
with either H4 or H7 bulbs.
DESCRIPTION
NOMINAL
MODEL
POWER
EW5430 36W
EW5431 40W
EW5432 80W
EW5433 20W
IMPORTANT!
Read all instructions before installing and using. Installer: This manual must be delivered to the end user.
!
WARNING!
Failure to install or use this product according to manufacturer's recommendations may result in property damage, serious bodily/
personal injury, and/or death to you and those you are seeking to protect! Check wattage before installing light to avoid possible
equipment damage.
Do not install and/or operate this safety product unless you have read and understand
the safety information contained in this manual.
1. Proper installation combined with operator training in the installation, use, care and maintenance of vehicle equipment accessories is
essential to ensure the safety of you and those you are trying to protect.
2. Exercise caution when working with live electrical connections.
3. This product must be properly grounded. Inadequate grounding and/or shorting of electrical connections can cause high
current arcing, which can cause personal injury and/or severe vehicle damage, including fire.
4. Proper placement and installation are vital to the performance of this driving lamp. Install this product so that output
performance of the system is maximized and the controls are placed within convenient reach of the operator so that s/he can
operate the system without losing eye contact with the road.
5. It is the responsibility of the installer to ensure that the lamp is mounted in accordance with local legislation.
6. The manufacturer assumes no liability for any loss resulting from the use of this device.
NOTE:
Black die cast Aluminum housing gets very hot to the
touch after operating constantly for several hours.
Page 1 of 5
P/N 920-5431-00 (Rev A) 2016-10-12
© 2016 at ECCO
RAW SIZE (mm)
LUMENS W x H x D
2393LM 350 X 37 X 55
3135LM 222 X 55 X 92
6270LM 414 X 55 X 92
1515LM 161 X 45 X 60
LED DRIVING LIGHT
EW5430 SERIES
COLOUR
WATERPROOF
TEMP
6000 - 6500K IP68
6000 - 6500K IP68
6000 - 6500K IP68
6000 - 6500K IP68
Caution: When drilling into any vehicle surface, make sure the
area is free from any electrical wires, fuel lines, vehicle
upholstery, etc. that could be damaged
LED QTY/
VOLTAGE
12 LEDS / 3W
4 LEDS / 10W
8 LEDS / 10W
4 LEDS / 5W
ECCO Safety Group Europe
Victoria Industrial Park, Victoria Road
Seacroft, Leeds, England
LS14 2LA
+44 (0)113 2375340
www.eccosafetygroup.com