Fluke FIBER ONESHOT PRO User Manual page 7


Do not use a magnifying device to look at the optical
outputs without the correct filter.

Use of controls, adjustments, or procedures that are
not in this manual can cause exposure to hazardous
radiation.
To prevent damage to fiber connectors, to prevent
data loss, and to make sure that your test results are
as accurate as possible:

Do not connect APC connectors to the troubleshooter.
An APC connector will cause damage to the fiber
endface in the connector on the troubleshooter. See
Figure 3.

Connect only UPC connectors to the troubleshooter.
Use only patch cords that comply with GR-326-CORE
specifications and have UPC connectors. Other patch
cords can cause unreliable measurements.

Use the correct procedures to clean all fiber connectors
before each test. If you do not do this or if you use
incorrect procedures, you can get unreliable test
results and can cause permanent damage to the
connectors.

Put protective caps on all connectors when you do not
use them.

Do not connect the troubleshooter to a network that
is on. If you do, the troubleshooter can cause problems
in the network.

If ACTIVE LINE blinks, immediately disconnect the
troubleshooter from the fiber. Optical power levels
more than +7 dBm can cause damage to the detector
in the troubleshooter.
W
Caution
WSafety Information
3