Advertisement
Quick Links
Advertisement
Related Manuals for Fluke FIBER QuickMap
Summary of Contents for Fluke FIBER QuickMap
- Page 1 GlobalTestSupply www. .com Find Quality Products Online at: sales@GlobalTestSupply.com...
-
Page 2: Limited Warranty And Limitation Of Liability
This warranty does not cover damage from accident, neglect, misuse, alteration, contamination, or abnormal conditions of operation or handling. Resellers are not authorized to extend any other warranty on Fluke Networks’ behalf. To obtain service during the warranty period, contact your... - Page 3 FIBER Q Multimode Troubleshooter. For UICK additional information, see the FIBER Q Multimode UICK Troubleshooter Users Manual on the Fluke Networks website. Safety Information Warning: Class 1 Laser To prevent possible damage to your eyes caused by hazardous radiation: ...
- Page 4 FIBER Q Getting Started Guide UICK Use only patch cords that comply with GR-326-CORE specifications and have UPC connectors. Other patch cords can cause unreliable measurements. Use the correct procedures to clean all fiber connectors before each test. If you do not do this or if you use incorrect procedures, you can get unreliable test results and can cause permanent damage to the connectors.
- Page 5 GlobalTestSupply www. .com Find Quality Products Online at: sales@GlobalTestSupply.com...
- Page 6 GlobalTestSupply www. .com Find Quality Products Online at: sales@GlobalTestSupply.com...
- Page 7 Settings R: Shows the reflectance of an incident on the fiber. The measurement is in decibels. MORE : Shows when the troubleshooter found more than one incident. Press to see the reflectance of the incidents. The numbers show the number of the incident and the total number of incidents.
- Page 8 GlobalTestSupply www. .com Find Quality Products Online at: sales@GlobalTestSupply.com...
- Page 9 GlobalTestSupply www. .com Find Quality Products Online at: sales@GlobalTestSupply.com...
- Page 10 Always use test cords that comply with GR-326-CORE specifications and have UPC connectors. Other cords can cause unreliable measurements. Fluke Networks recommends that you use launch and receive fibers. See the Users Manual. Clean all fiber connectors. Connect the fiber to the troubleshooter (Figure 5).
- Page 11 How to Use the Troubleshooter Installed fiber Patch panel Patch panel Launch fiber WUPC connector only Receive fiber Note: Always use test cords that Unterminated comply with GR-326-CORE spool of fiber specifications and have UPC connectors. Mechanical splice WUPC connector only gbw05.eps Figure 5.
- Page 12 GlobalTestSupply www. .com Find Quality Products Online at: sales@GlobalTestSupply.com...
- Page 13 GlobalTestSupply www. .com Find Quality Products Online at: sales@GlobalTestSupply.com...
Need help?
Do you have a question about the FIBER QuickMap and is the answer not in the manual?
Questions and answers