Before Mounting; Required Tools - Bosch Rexroth WE6/BVP1 Series Operating Instructions Manual

7.3.1 Requirements on the valve subplate
Explosion hazard caused by overheating!
In case of non-compliance with the requirements on the valve subplate, explosion
protection is no longer ensured!
▶ Observe the prescribed minimum distance in case of the assembly of several
valves in a valve battery.
▶ Observe the prescribed minimum size and minimum thermal conductivity of the
valve connection surface.
For recommended subplates, refer to chapter 7.6 "Required accessories".
The following minimum values of the valve subplates must be adhered to:
Table 10: Minimum values of the valve subplates
Position
Thermal conductivity
Minimum size L x W x H for individual mounting
Minimum cross-section W × H of the manifold in case of bank
assembly of several valves
Minimum distance between the longitudinal valve axes in case of
the bank assembly of several valves

7.4 Before mounting

Explosion hazard due to the wrong area of application!
A valve which is not approved for the area of application may cause an explosion!
▶ Check whether the explosion protection marks on the nameplate of the solenoid
system comply with the information in these operating instructions.
▶ Check whether you have the correct valve type by means of the type designation
on the nameplate of the valve.
▶ Check whether the "Class, Division" specifications and the temperature class
correspond to the area of application of the valve.
▶ Check the scope of delivery for completeness and possible transport damage.
▶ Also observe the safety instructions in chapter 2.6 "Product-specific safety
instructions".

7.5 Required tools

In order to mount the valve, you need standard tools only.
wARnInG
wARnInG
RE23178-VP1-B/06.16, WE 6../.B..VP1..., Bosch Rexroth AG
Mounting 23/48
Minimum value
at least 38 W/mK
64 x 58 x 25 mm
85 x 60 mm
55 mm