Table of Contents
Advertisement
Change position of the jib arm
The articulating arm can be fastened in three different positions to accommodate different operating
environments.
1. Choose one of the three mounting positions depending on the operational requirements and on
which side of the lifter the user is most likely to operate on, see Mounting position on page 12.
2. Place the provided rubber gasket on the mounting position and mount the articulating arm with the
six provided bolts (use a torque of 24 Nm) (a).
3. Connect the provided electrical cable between the articulating arm and the electrical receptacle on
the tower (b).
b
• These instructions must be carefully followed. failure to do so may cause the unit to fall down and
cause bodily injuries.
• Make sure the bolts are fastened correctly and that the correct torque is applied. Do not over- or
undertighten. Air leakage may occur otherwise, reducing lift capacity.
x 6
USER INSTRUCTIONS• 5
a
31
Advertisement
Table of Contents
