Table of Contents
Advertisement
8/56
Safety instructions
Bosch Rexroth Corporation, A21VG Series 10, RE 93223-01-B/09.2020
2 Safety instructions
2.1 About this chapter
The axial piston unit has been manufactured according to the generally accepted
rules of current technology. There is, however, still a danger of personal injury
or damage to equipment if this chapter and the safety instructions in this
documentation are not complied with.
▶
Read this documentation completely and thoroughly before working with the
axial piston unit.
▶
Keep this documentation in a location where it is accessible to all users
at all times.
▶
Always include the required documentation when you pass the axial piston
unit on to third parties.
2.2 Intended use
Axial piston units are hydraulic components, meaning that in their application area
they are classified neither as complete nor as incomplete machines in the sense
of the EU machine directive 2006/42/EC. A component is exclusively intended to
form an incomplete or a complete machine together with other components. The
component may only be commissioned after it has been installed in the machine/
system for which it is intended and the safety of the entire system has been
established in accordance with the machine directive.
The product is intended for the following use:
The axial piston unit is only approved as a pump for hydrostatic drives in closed
circuit.
▶
Observe the technical data, application and operating conditions and
performance limits as specified in data sheet 93223 and in the order
confirmation. Information about approved hydraulic fluids can be found in data
sheet 93223.
The axial piston unit is only intended for professional use and not for private use.
Intended use includes having read and understood the complete documentation,
especially the chapter 2 "Safety instructions" on page 8.
2.3 Improper use
Any use other than that described as intended use shall be considered as improper
and is therefore impermissible. Bosch Rexroth AG shall accept no liability
whatsoever for damage resulting from improper use. The user shall bear all risks
arising from improper use.
Similarly, the following foreseeable faulty usages are also considered to be
improper:
• Use outside the operating parameters approved in the data sheet or in the order
confirmation (unless customer-specific approval has been granted)
• Use for non-approved fluids, e.g. water or polyurethane components
• Modification of factory settings by non-authorized persons
Advertisement
Table of Contents
