Redback E522D Operation Manual page 15

8. Never touch wire fences or the
ground with the running cutting
mechanism. If cutting hedges over a
prolonged period, interrupt your work
more frequently and oil the cutter bar.
9. Switch the engine off and remove
the battery:
- to remove blockages (jammed
clippings) from the cutting bar;
- if the unit behavior changes or it
vibrates unusually;
- if you have come into contact with
foreign objects or the ground;
- when taking breaks and leaving the
unit unattended.
NOTE: If the power tool is damaged or
vibrates unusually, it must be repaired by
a service center before it is used again.
10. After use, stop the motor and wait
until all rotating parts have come to a
standstill.
11. Place the protection hood on the
cutter bar.
Cutting Techniques
The hedge trimmer can be guided with
its double-sided cutters forwards and
backwards or in an oscillating
movement.
14
•
Cut the sides of the hedge first and
then the top.
- When cutting sideways, hold the
handlebar sideways.
- When cutting low down, hold the
handlebar above.
• Cut the hedge from bottom to top.
• Hold the hedge trimmer at an angle of
5-10° to the hedge to ensure a
straight cut.
•
Cut the hedge in a trapezoidal
shape. This prevents the lower part of
the hedge from losing its foliage due to
lack of light.