Redback E522D Operation Manual page 14

Charging the Battery
1. Plug the charger into an AC outlet
100-250V (normal household voltage).
2. Insert the battery into the slots of the
charger and slide
into place until the battery locks into
place
3. The LED will flash green while the
battery is charging.
- Once the battery is fully charged, the
LED indicator will show a steady green
light.
- Remove the battery by pressing and
holding the latch button and sliding out
of the charger. Lithium Ion batteries
have no memory effect – a partial
charge will not damage your battery.
Battery State of Charge
Press the button to check the state of
charge at the state of charge indicator
LED.
The indicator goes out after 3 seconds.
If the LED lights red, the battery must be
recharged. If the LED doesn't light up
after the button is pressed, the battery is
faulty and must be replaced.
13
Cleaning the Cutter Bar
(after each use)
• Remove the battery.
• Clean the cutter bar after each use.
Remove contamination, remains of
blades etc.
•
Spray the cutter bar with
maintenance oil to ensure that the
hedge trimmer has a long service life.
Preferably use environmentally friendly
lubricants, e.g. service sprays.
CAUTION! Do not oil the hedge trimmer
while it is running.
Work Instructions
1. Check that all parts are firmly
attached and obviously undamaged.
2. Look over the working area and
remove any obstructions. Remove all
foreign objects from the hedge, such as
wire or other parts, as these may block
or damage the cutting mechanism.
3. Cut out thick branches beforehand
using pruning shears.
4. Pick up the power tool in both
hands as specified.
5. Always cut at full engine speed.
6. Start cutting only with the cutting
mechanism running.
7. The impact guard protects you
against unpleasant impacts, e.g. recoil
torque of the cutter, when striking a solid
object (wall, ground, etc.).