INVENTOR K2VI32-09WFI User Manual page 13

Operation -- Installation and removal of IFD
1.Brief introduction of the mechanism (the figure is the sketch of the parts, please refer to the real object)
Upper bracket slot
Upper buckle
Left mounting frame
2. Install the filter element
①
Unplug the power plug of the air conditioner,
and open the panel upwards by about 90° (the
panel will automatically get stuck).
③
Snap the lower buckle of the filter element into
the lower bracket slot and ensure that the buckle
is in place.
3. Remove the filter element
*
Note: Before the installation and removal of the dust removal filter element, the air conditioner should exit
the purification state and shut down after 5 minutes to replace the filter element.
Do not cut off the power supply directly and replace the filter element when the air conditioner is in
the process of purification.
The operating steps of the filter element on the right are the same as those of the filter element on
the left.
The IFD filter elements include a left one and a right one (L/R).
L
②
Snap the upper buckle of the filter element into
the upper bracket slot and ensure that it is in
place.
④
Install the other filter element in the right frame
according to the operating steps ② and ③;
Check and make sure that the filter element is
flush with the arc surface of the mounting
frame.
Turn the lower buckle of the filter element by hand to
make the buckle out of the slot, rotate it in the
direction shown in the figure and pull the filter
element out.
11
Right mounting frame
Lower bracket slot
3
Lower buckle
R
L
*
11