NRS Healthcare N05370 User Instructions

N05370
General Safety Warning
Please make sure that you read and follow
these instructions carefully. Keep these
instructions in a safe place for future reference.
1.

INTENDED USE

The NRS Healthcare Bathroom Step is designed to assist the user while transferring into or out of the bath,
by reducing the step-over height.
2.

SAFETY

Warning: The maximum user weight must not be
more than 190Kg (30st).
The maximum step height is 8" (200mm) using 3
steps (purchased separately).
Do not stack more than 3 steps together.
Always use extreme caution when getting in or out
of a bath.
3.

UNPACKING

Remove the packaging and check all parts carefully.
Contact your supplier immediately if parts are
missing or damaged and do not try and assemble.
3.1 Contents:
1. 100mm (4") Step (complete with four
assembled caps) x 1
2. Anti-Slip Mat (Self Adhesive backed) x 1
3. User Instructions x 1
4.

ASSEMBLY

No tools are required to assemble this product.
(However, a fl at headed screwdriver, or similar,
would help to remove the caps if the steps are to be
assembled in a multiple stack).
There are a number of options and combinations the
steps can be used for.
A single step provides a step height of 4"(100mm).
USER INSTRUCTIONS
Bathroom Step
BATHROOM STEP
Single Step Use: Unpack the step, ensure it is clean
and dry, remove the protective fi lm from the back of
the self-adhesive mat and place accurately on top of
the step. Ensure the mat is in the recess on the top
of the step and there are no creases, press down
fi rmly to secure.
Multiple Step Use: Stacking Options (Steps
purchased separately).
• Single: 4" (100mm)
• Two Steps: 6" (150mm)
• Maximum 3 High: 8" 200mm).
Note: The Anti -Slip mat is placed on the top step
only. Mats supplied with the other steps should be
saved, to be used later as spares.
Stacking assembly: The top step should be
assembled as described in the single step use
section.
For all other steps used in the stack, remove the four
caps as shown in Figures 1 & 2.
Note: a fl at bladed screwdriver may help to do this.
Please use caution if tools are used.
Remove all four caps.
1
Maximum User Weight
30st
190kg
Figure 1: