User-Maintenance And Storage; Cleaning, Maintenance, And Lubrication; Cleaning Filters; Cloth Filter - Bauer 1952E-B3 Owner's Manual & Safety Instructions

user-maintenance and Storage

procedures not specifically explained in this manual must
be performed only by a qualified technician.
tO prEVEnt SEriOuS inJury FrOM acciDEntaL OpEratiOn:
turn the power Switch of the appliance off and unplug the appliance from its
electrical outlet before performing any procedure in this section.
tO prEVEnt SEriOuS inJury FrOM appLiancE FaiLurE:
Do not use damaged equipment. if abnormal noise or vibration
occurs, have the problem corrected before further use.

cleaning, Maintenance, and Lubrication

1. BEFOrE EacH uSE, inspect the
general condition of the appliance. Check for:
• loose hardware
• misalignment or binding of moving parts
• air leakage on the Tank or Power Head connection
• cracked or broken parts
• damaged electrical wiring
• any other condition that may
affect its safe operation.

cleaning Filters

to ensure proper operation, clean the Filters regularly. torn Filters should be replaced:

cLOtH FiLtEr:

1. Gently tap or brush dirt off outdoors.
2. Wash Cloth Filter using mild soap and water.
3. Rinse all soap and dust out thoroughly.
4. allow the cloth Filter to dry for at
least one day before reinstalling.
WarninG! installing a wet Filter
will increase the risk of electric shock
and may damage the vacuum.
5. Reinstall the Filter. Make sure it covers
the Filter Cage completely.
Page 8 For technical questions, please call 1-888-866-5797.
2. aFtEr uSE, wipe external surfaces of
the appliance with clean cloth. Store in an
indoor dry area out of reach of children.
3. All parts are permanently lubricated.
Do not use additional lubrication.
4. WarninG! if the supply cord of this
appliance is damaged, it must be replaced
only by a qualified service technician.
FOaM FiLtEr:
nOticE: Do not wring the Foam Filter.
Wringing the Foam Filter will tear its
internal structure and ruin it.
1. Gently wash Foam Filter using mild soap and water.
2. Rinse all soap and dust out thoroughly.
3. allow the Foam Filter to dry for at
least one day before reinstalling.
WarninG! installing a wet Filter
will increase the risk of electric shock
and may damage the vacuum.
4. Reinstall the Filter. Make sure it covers
the Filter Cage completely.
Item 64753