Operating Instructions; Vacuum Operation; B: Wet Vacuum Setup; A: Dry Vacuum Setup - Bauer 1952E-B3 Owner's Manual & Safety Instructions

Operating instructions

read the EntirE iMpOrtant SaFEty inFOrMatiOn section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.

Vacuum Operation

tO prEVEnt SEriOuS inJury FrOM acciDEntaL OpEratiOn:
turn the Switch off and unplug the power cord from its electrical outlet before removing the power Head.
1. Pull out on the tabs on the sides of the
Power Head and pull up on it to remove it.
2. For dry vacuuming: Install Foam Filter completely
onto the Filter Cage. Install Cloth Filter over the
Foam Filter and secure with the Clamp Ring.
Vacuum
port
Figure a: Dry Vacuum Setup
Item 64753
tab
Filter
cage
Foam
Filter
clamp
ring
cloth
Filter
For technical questions, please call 1-888-866-5797.
3. For wet vacuuming: Confirm that the float
within the Filter Cage can move freely. Install
Foam Filter completely onto the Filter Cage.
Vacuum
port
Figure B: Wet Vacuum Setup
4. Reassemble the Power Head to the Tank,
making sure the tabs lock into place.
note: The Power Head must properly seal onto
the Tank and the Tank must be undamaged
to allow the vacuum to create suction.
5. Insert the longer end of the Hose
securely into the Vacuum Port.
6. If desired, slide a Nozzle onto the Hose.
tab
Filter
cage
Foam
Filter
Page 5