Silvercrest SEMM 1470 A2 Operating Instructions Manual page 62

6) Clean the silver attachment and the milk nozzle 0 that you have removed
from the milk tank lid 4 along with the positioning lever o in warm water
with a little washing-up liquid. Rinse all parts afterwards with plenty of clean
water.
7) Afterwards, replace the silver attachment onto the milk nozzle 0 and set it
at the desired height (see section "Setting the milk nozzle").
8) Push the milk nozzle 0 and the positioning lever o back into the milk tank
lid 4 and push the connector assembly all the way back into the appliance.
For thorough cleaning, the connecting plug can be removed from the milk tank
lid 4:
1) Turn it towards the
2) Clean connecting plug with tap water.
Afterwards, dry it thoroughly.
3) Refit the connecting plug on the milk tank lid 4 by turning it towards the
symbol.
To clean the milk tank lid 4 thoroughly, proceed as follows:
1) Take off the milk tank lid 4.
2) Remove the rubber cover from the milk tank lid 4.
3) Turn the knob 5 clockwise until the marking on the knob 5 is pointing
downwards.
4) Allow fresh water to run through the openings while moving the milk tank
lid 4 gently from side to side.
SEMM 1470 A2
symbol and pull it out.
GB │ MT │
59 ■