Before First Use - Silvercrest SEMM 1470 A2 Operating Instructions Manual

Before first use
1) Clean the sieve holder p, the measuring spoon f, the espresso sieves s
d, the drip grille 8, the drip tray 7, the tray for small cups 9 the milk
tank 6, the milk tank lid 4, the water tank lid t and the water tank z
as described in the section "Cleaning and care".
2) Place the appliance on a level and heat-resistant surface. Ensure that the
mains outlet is in easy reach.
3) Insert the drip tray 7 and place the drip grille 8 on it.
4) Insert the sieve holder p together with the espresso sieve (s or d) into the
appliance by inserting it at the "
turning it anticlockwise until the handle of the sieve holder p is pointing to
the "
5) Insert the plug into a mains power socket.
NOTE
6) Before first use, proceed as follows to clean the internal pipes:
–
fill the water tank z with water (approx. 200 ml), and also the milk
tank 6 (approx. 100 ml).
–
Insert the water tank z and the milk tank 6 in the appliance.
–
Place a large cup on the drip grille 8.
–
Set the milk nozzle 0 so that the milk nozzle 0 is pointing into the cup.
–
Switch the appliance on using the on/off switch i (position I). All the
control lamps begin to flash. As soon as all the lamps light up
permanently the appliance has heated up.
–
Press the "Large" cappuccino button
coming out of the espresso outlet q and all control lamps light up
permanently. Repeat this process 2x.
–
Switch the appliance off using the on/off switch i (position O).
–
Empty the remaining water from the water tank z and the milk tank 6.
NOTE
► You should also clean the appliance as described here after long periods
out of use.
The appliance is now ready for use.
SEMM 1470 A2
" symbol.
Remove the orange transport restraint from the bottom of the
water tank z!
" marking on the appliance and then
2. Wait until water stops
GB │ MT │
43 ■