Operating The Leak Detector With The Charger Connected - Bosch CS LD 1.0 Operator's Manual

en | 46 | CS LD 1.0 | Maintenance
Fig. 18: Charging Leak detector
1. Charging port
i i
Always use a locally approved
5V DC charger with an output
of at least 1.0A.
It is also possible to use a 12V DC
power source if the USB adapter
outputs a minimum 1.0A.
•
With the leak detector off and
the charger connected, the
screen will display charging
status as shown in Fig. 20. Char-
ge the leak detector until the
display shows 100%.
•
Charging time to full capacity is
approximately 3 hours.
|
F 002 DG9 H12 2021-04-08
Fig. 19: Charging status icon (power off)
7.4.3 Operating the leak
detector with the charger
connected
It is possible to operate the
leak detector with the charger
connected.
•
Connect the charger as descri-
bed in section 7.4.2 and turn
on the leak detector.
•
With the leak detector on and
the charger connected the dis-
play will indicate charging and
progress with the lightning bolt
symbol in the upper right corner
of the screen, see Fig. 21.
Bosch Automotive Service Solutions GmbH
50%