Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Bosch LTC 2210 Series
Summary of Contents for Bosch LTC 2210 Series
- Page 1 LTC 2210 Series Instruction Manual EN Motion Detector...
-
Page 2: Important Safeguards
LTC 2210 Series | Instruction Manual | Important Safeguards Important Safeguards 1. Read, Follow, and Retain Instructions - All safety and operating instructions should be read and followed before operating the unit. Retain instructions for future reference. 2. Heed Warnings - Adhere to all warnings on the unit and in the operating instructions. -
Page 3: Fcc Information
LTC 2210 Series | Instruction Manual | FCC Information For Indoor Product 1. Water and Moisture - Do not use this unit near water - for example, in a wet basement, in an unprotected outdoor installation or in any area classified as a wet location. -
Page 4: Safety Precautions
LTC 2210 Series | Instruction Manual | Safety Precautions Safety Precautions CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. This symbol indicates the presence of uninsulated “dangerous voltage”... -
Page 5: Table Of Contents
LTC 2210 Series | Instruction Manual | Contents Table of Contents Important Safeguards ..............2 FCC Information . -
Page 6: Unpacking
LTC 2210 Series | Instruction Manual | Unpacking UNPACKING This equipment should be unpacked and handled with care. If an item appears to have been damaged in shipment, notify the shipper. Verify that all parts shown in the Parts List have been included. -
Page 7: Alarm/Accessory Connector
LTC 2210 Series | Instruction Manual | Operatio 4.5 Alarm/Accessory Connector A cable with a connector is supplied connecting to alarm closures or other accessories. The alarm output creates a short between the two output pins (pins 9 and 14 Alarm Relay (NO)) when an alarm occurs and open-circuits the pins when no alarms are active (triggered). -
Page 8: Zone Setup
LTC 2210 Series | Instruction Manual | Operation 5.3 Zone Setup This menu is used to define the areas where motion can be detected. A total of 8 different zones can be defined. Unrestricted areas where motion is permitted and other unnecessary areas should not be included in the active zones. -
Page 9: Detection Sensitivity
This option is programmed from the Zone Setup menu. It defines the percentage of total screen width or height that the target must cross before the LTC 2210 Series will generate an alarm signal. The following chart may be used as a guide to arrive at the correct... -
Page 10: Display
ON/OFF OVERSCAN Bosch Security Systems | December 17, 2004 1. The LTC 2210 can detect motion over the full active video signal, however all of this cannot be displayed on the video monitor as most video monitors cannot display the entire active video signal. This parameter... -
Page 11: Illustrations
LTC 2210 Series | Instruction Manual | Illustrations ILLUSTRATIONS Figure 1 Front and Back Panels 6 11 7 12 8 13 9 14 5 10 15 NOTE: NC designates No Connection, NO designates Normally Open. Figure 2 ALARM/ACCESSORY Connector Bosch Security Systems | December 17, 2004... - Page 12 LTC 2210 Series | Instruction Manual | Illustrations Camera #2 Camera #1 Additional Came ras Hi-Z Switcher To Terminated Auxi liary Monitor or Te rminated Switcher Figure 3 Typical Installation Bosch Security Systems, Inc. 850 Greenfield Road Lancaster, PA 17601 USA...