Advertisement

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Sensero-868 AC and is the answer not in the manual?

Questions and answers

Summary of Contents for elero Sensero-868 AC

  • Page 2: Safety Instructions

    Note The device will only work in connection with compatible Observe all safety instructions for radio radio receivers from the range of the elero radio system. operation! Manual operation of the system is carried out with a hand- held/wall transmitter. This item is not included in the scope of delivery.
  • Page 3: Exclusion Of Liability

    Exclusion of liability  Do not touch the rain sensor! elero GmbH assumes no liability for personal injuries, property damage and fi nancial losses which arise from modifi cations to the device, improper use and a failure to observe the Mounting instructions.
  • Page 4: Programming The Device

    The light threshold value must be set to 2 or higher. To keep the blind closed even in the evening, close the blind manually using a hand-held transmitter or an elero timer. The current transitions of the light sensor measured values from 1 to 0 (late in the evening) or from 0 to 1 (early in the morning) will be ignored.
  • Page 5: Symbols At The Device

    Factory setting Level 1 Travel down at darkness Twilight Settings 2 Intermediate levels to 13 Level 14 Travel down at start of twilight Note The factory settings for OEM devices may differ from the above. EN 4 © elero GmbH...
  • Page 6: Rain Function

    The measured wind value exceeds the set threshold value; minutes. the wind signal is triggered. Rain function The integrated rain sensor in the Sensero AC Plus measures the rain volume and compares it to the threshold value. © elero GmbH EN 5...
  • Page 7: Maintenance

    The blind does WIND threshold value is Adjust the WIND  Keep away from the operating range of the not travel up set incorrectly threshold value. when it is system. windy. EN 6 © elero GmbH...
  • Page 8 All LEDs fl ash Wind sensor is wet; device Allow the wind sensor is defective to dry Repair Please contact your dealer if you have any queries. © elero GmbH EN 7...
  • Page 9: Ec Declaration Of Conformity

    EN 61000-6-2:2005, EN 61000-6-3:2001 EN 60730-1:2000, EN 60730-2-7:1991 • Low Voltage Directive 2006/95/EC EN 60335-1:2002 • R&TTE Directives 1999/5/EC ETSI EN 301 489-3 V1.4.1 ETSI EN 300 220-2 V2.1.2 • RoHS Directive 2002/95/EC Beuren, 05.07.2012 Ralph Trost -CE Manager-, -Representative documentation - www.elero.com...

Table of Contents