elero Lumo-868 Operating Instructions Manual
elero Lumo-868 Operating Instructions Manual

elero Lumo-868 Operating Instructions Manual

Hide thumbs Also See for Lumo-868:

Advertisement

Quick Links

elero GmbH
Antriebstechnik
Linsenhofer Str. 59–63
D-72660 Beuren
info@elero.de
www.elero.com
309020
Lumo-868
Operating instructions
GB
Please take care of the operating instructions!
Nr. 18 100.6201/0205
elero

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Lumo-868 and is the answer not in the manual?

Questions and answers

Summary of Contents for elero Lumo-868

  • Page 1: Operating Instructions

    Lumo-868 Operating instructions Please take care of the operating instructions! elero GmbH Antriebstechnik Linsenhofer Str. 59–63 D-72660 Beuren info@elero.de www.elero.com 309020 Nr. 18 100.6201/0205...
  • Page 2 • Only use unmodified original elero-electrical Installation of Lumo-868 ........GB- 5 parts.
  • Page 3: General Information

    In addition to that, a glass breakage sensor is located Threshold controller for sunlight within the device. Indicator lamp Threshold controller A manual use of the Lumo-868 is possible at any given time. for twilight Intended use UP-/STOP-Button The Lumo-868 may only be used for controlling roller shutter CR2032 or sun protection devices.
  • Page 4 Glass breakage function off 4. Lower position Setting mode off Opening the Lumo-868 1. Turn the housing cover (2 mm) in a clockwise direction. Closing the Lumo-868 1. Make sure that the engaging hook and reception is in the correct position when you close the cover.
  • Page 5 Through the inclination of the Lumo-868, you can adjust the lowered until the Lumo-868 is shaded, it is stopped and the light sensitivity of the glass breakage sensor. sensor is open again.
  • Page 6 The roller shutter will not automatically go back in the UP-position. The blind has to carry out an up travel through a manual command with the UP button on the Lumo-868, through a timer or through another programmed transmitter. The sun threshold controller is preset to a mean value.
  • Page 7 Setting The following operating modes are possible: TEST mode In this mode you can test the Lumo-868. In the TEST mode, the Sun function activated twilight-/glassfunction 1 2 3 4 time interval for the shading function is reduced from minutes to deactivated seconds.
  • Page 8 Clean the device with a damp cloth only. Do not use cleaning General conformity declaration: solutions, as these may damage the plastic. Herewith the company elero GmbH declares that the Lumo-868 device satisfies the basic requirements and other relevant regulations of the 1999/5/EU guidelines.

Table of Contents