Maintenance And Care - Flex RFE 40 18.0-EC Original Operating Instructions

RFE 40 18.0-EC
1. Secure the reversible blades and check
that they are seated firmly.
2. Check the chasing depth, adjust if
necessary.
3. Switch on the power tool.
4. Bring the gutter bracket chaser into
position on the working surface.
The rest plate must be flush with the
working surface.
5. Guide the chaser over the material with
even pressure.
Only use batteries and battery chargers of the
manufacturer.
The order numbers are on our homepage:
www.flex-tools.com
 Do not use damaged batteries. These
should be replaced straightaway.
 Do not remove the battery.
 Permissible ambient temperature (power
tool, battery charger, battery)
– During charging
– During operation
– In storage
4 ... +40 °C
-20 ... +50 °C
-20 ... +50 °C

Maintenance and care

WARNING!
Remove the battery before carrying out any
work on the power tool.
Cleaning
WARNING!
Do not use water or liquid detergents.
 Regularly clean the power tool and
ventilation slots.
 Regularly blow out the housing interior
and motor with dry compressed air.
 Clean the dust filter at regular intervals.
 Remove the dust filter and blow out with
dry compressed air.
Gears
NOTE
Do not loosen the screws on the gear head
during the warranty period. Failure to comply
with this requirement will invalidate any
claims under the manufacturer's warranty.
Repairs
Repairs may only be carried out by an
authorised customer service centre.
Spare parts and accessories
Other accessories, in particular cutting
accessories, can be found in the
manufacturer's catalogues.
Exploded drawings and spare part lists can be
found on our homepage:
www.flex-tools.com
17