Flex RFE 40 18.0-EC Original Operating Instructions page 16

 If all sides of the reversible blade are already
worn, insert a new reversible blade.
 Perform the same procedure for all 4
reversible blades.
Adjusting the chasing depth
A chasing depth of between 6 mm to 8 mm
can be selected.
Adjustment of the chasing depth is carried out
by removal and assembly of the rest plate.
 Using a screwdriver, loosen the screws
securing the rest plate by turning in anti-
clockwise direction (1.).
 Remove the rest plate (2.).
The chasing depth is now 8 mm.
 If a chasing depth of 6 mm is required,
reinstall the rest plate.
Switching the power tool on/off
 Push the switch rocker forwards and hold
in position.
 To switch off the power tool, release the
switch rocker.
16
NOTE
The switch rocker cannot be engaged
because of safety reasons.
CAUTION!
The chaser head continues to run after
switching off.
Speed preselection
– To set the operating speed, press the
speed regulation button. The speed
selection remains set even after
switching off.
– Press the switch carefully to accelerate the
power tool to the preselected speed.
CAUTION!
Risk of injury from disintegration of the tool.
Use a tool appropriate for the task at hand.
NOTE
– Overload protection: Switches the
machine off in the event of overload.
– Temperature monitoring: The machine
will switch off if there is a risk of
overheating.
Working with the power tool
WARNING!
The chaser head must not come into contact
with sharp, protruding items. Risk of
kickback! Damage to chaser head. If the
reversible blades are damaged or heavily
worn, they must be replaced without fail.
CAUTION!
Always hold the power tool firmly with both
hands!
RFE 40 18.0-EC