Front Light Group - VESPA GTS 250 i.e. Manual

Fuse No. 9 Capacity: 7.5 A
Protected circuits: Daylight
running lights, license plate light,
instrument panel lighting.

Front light group (03_26, 03_27, 03_28, 03_29, 03_30)

To remove the front headlight assembly, proceed as follows:
1: remove rear-view mirrors.
2: Remove the screw «A» of the front shield grille.
3: Remove the fixing screws «B» of the front handlebar cover.
4: Remove the fixing screws «C» of the rear handlebar cover
5: Remove the front handlebar cover.
So there is access to the bulbs. Open the ring nut and take out the high-/low-beam
light bulb «D». To change the tail light take out the rubber bulb socket from its fitting.
To reassemble, repeat the operation in the reverse order.
WARNING
THE TWIN-FILAMENT (HIGH-BEAM AND LOW-BEAM) BULB IS HALOGEN: DO
NOT TOUCH THE BULB WITH YOUR FINGERS TO AVOID COMPROMISING ITS
FUNCTIONING
N.B.
IF MISTING IS NOTICED ON THE INSIDE OF THE HEADLAMP GLASS, THIS
DOES NOT INDICATE A FAULT AND IS ATTRIBUTABLE TO HUMIDITY AND/OR
TO LOW TEMPERATURES.
54