Fuses; Front Light Group - VESPA PX 125 Manual

Fuses (03_11)

Both starting system and horn are protected by a 7.5 A fuse «A» placed on the battery
mounting left side. Before replacing the blown fuse, find and solve the problem that
caused it to blow. Do not replace the fuse with any alternative form of conductor
CAUTION
BEFORE REPLACING A BLOWN FUSE, FIND AND SOLVE THE FAILURE THAT
03_11
CAUSED IT TO BLOW. NEVER TRY TO REPLACE THE FUSE WITH ANY OTHER
MATERIAL (E.G., A PIECE OF ELECTRIC WIRE).
CAUTION
MODIFICATIONS OR REPAIRS TO THE ELECTRICAL SYSTEM, PERFORMED
INCORRECTLY OR WITHOUT STRICT ATTENTION TO THE TECHNICAL SPEC-
IFICATIONS OF THE SYSTEM CAN CAUSE MALFUNCTIONING AND RISK OF
FIRE.

Front light group (03_12)

To reach the headlight bulbs, remove the top handlebar cover, as described below.
After removing the driving mirrors, loosen the two screws, «A», and the two opposite
screws underneath the handlebar. Lift cover «B» and release the two springs which
allow extracting the bulb socket from its housing. To remove the bulbs, push down-
wards and rotate them anticlockwise. To replace warning light bulbs, it is sufficient to
pull them off.
03_12
37