Install the new Transfer Roller by
5.
holding the Lock Levers of the
Transfer Roller and adjusting the
angle of the Transfer Roller Lever
shafts (both sides) to match the
Transfer Unit groove. Set the
Transfer Roller onto the shafts and
place the Roller onto the springs as
shown below:
Transfer Roller Shaft
Spring
Push down the Lock Lever to lock the Transfer Roller into place.
6.
Close the Rear Access Cover.
7.
Plug the printer into the AC outlet.
8.
Press the Power button to turn on the printer.
9.
Lock Levers
Fig. 5-35
5-33
CHAPTER 5 MAINTENANCE
Fig. 5-34
Fig. 5-36