Routine Cleaning; Periodic Cleaning/Descaling - Bunn MCP Use And Care Manual

Before beginning any cleaning procedure, unplug the brewer to
avoid the accidental start of a brew cycle.
Clean the pod holder, drip tray and drip tray grate after each
use, using a damp cloth and mild detergent and rinse. With the pod
holder and drip tray removed, use a damp cloth with mild detergent
to wipe the area below the pod holder and into the drip tray area.
Occasionally, wipe the outside of the brewer with a damp cloth.
(The reservoir, slide lid, pod holder, drip tray and drip tray grate are
dishwasher safe.)
Periodically, you should clean and descale the brewer to clear any mineral deposits
that may have accumulated due to impurities in the water source. If these deposits are not
removed, they can impair the operation of the brewer and reduce the product life.
There are several products available specifically for descaling. We recommend using
URNEX Activated Descaler or JavaClean2 Cleaner and Descaler, available on our web
®
site: www.bunn.com. (White vinegar can be used to descale if a descaling product is not
available.)
Follow the directions as printed on the manufacturer's package.
1) Fill the reservoir with descaling product as described by the manufacturer's directions,
or 32 oz. (946 ml) of white vinegar. Do not add powder mix
directly to the reservoir. Descaling product must be mixed
into a solution before it is added to the reservoir.
2) Place an empty pod holder into the brewer. Be sure the holder
is locked into place, and set the VOLUME CONTROL SLIDE
LEVER to the maximum position.
3) Place an empty container or bowl on the drip tray grate that
will hold at least 14 oz. (414 ml) of liquid, and press the
COFFEE BREW BUTTON to start a brew cycle.
4) Once the brew cycle has finished, empty the container and
set it back onto the drip tray grate. Press the COFFEE BREW
BUTTON again to start a second brew cycle.
5) Once the brew cycle has finished, empty the container and
the remaining solution, or vinegar from the reservoir. Remove
the pod holder; clean the reservoir and pod holder thoroughly
using a mild detergent, then rinse.
NOTE: There is now descaling solution in the internal tank. Follow
the manufacturer's directions if the solution must be left in the tank
for any period of time. For vinegar, allow the solution to sit for at
least two, but no more than four hours.
6) Fill the reservoir to the "MAX" line with fresh clean cold water
and place the pod holder back into the brewer.
7) Place the empty container back onto the drip tray grate and
press the COFFEE BREW BUTTON to begin a brew cycle.

ROUTINE CLEANING

PERIODIC CLEANING/DESCALING

(Recommended At Least Once a Month.)
11
P2963
P3028
P2958
P2908