Communicating With A Brewer - Bunn G9-2T DBC Installation And Operating Manual

When the grinder is used with its companion brewer, the name of the coffee and the size of the batch ground
is communicated to the brewer through the chip in the funnel handle as it is placed into the brewer. Therefore,
it is necessary to "tell" the grinder the names of the coffees that have been loaded into the hoppers. The names
are chosen from the Coffee Chart shown below. Contact the factory if custom names that are not on the chart
are required.
Entering a coffee name from the chart below:
1. Simultaneously press and hold the STOP button and any one of the three batch buttons on the side to be
programmed. After 3 seconds all three indicators on the side selected will begin flashing. The display will
show a number from the coffee chart below. This number represents the name of the coffee that is to be
loaded into the hopper.
2. Press and release the GRIND button to increase the number or press and release the STOP button to decrease
it.
3. When the correct number for the coffee being used is displayed, press any of the batch buttons on the other
side. All three indicators on that side will begin flashing.
4. Repeat step 2 to enter the name for the coffee being used on this side.
5. To exit the setup mode, press and release the ® button anytime during this procedure. The ® button is a
hidden programming pad located at the upper right corner of the BUNN
Entering a coffee name using a RECIPE CARD.
1. Press the STOP button and place the chip portion of the card under the sensor coil on the front of the
grinder.
2. After a short pause, the display will show 3 "dashes".
3. Remove the card and press any batch switch on the side to be programmed.
4. The display should show the number of the coffee name loaded into the grinder.
5. The grinder display will then return to the normal operating mode.
COMMUNICATING WITH COFFEE BREWER
SELECTING COFFEE NAMES
logo.
®
6
33736 030205