User Notices; Electrical Requirements - Bunn G9-2T DBC Installation And Operating Manual

Bunn g9-2t dbc: operating manual
Hide thumbs Also See for G9-2T DBC:
Table of Contents

Advertisement

This equipment will store up-to six pounds of whole bean coffee in each of two hoppers and grind it to a preset
grind and amount into an awaiting funnel and filter from most commercial drip coffee brewers. The equipment
is only for indoor use on a sturdy counter or shelf. Adequate space must be available above the grinder to raise
the lids when adding beans. Use only with whole bean coffee.
The grind is preset at the factory to drip specifications as set forth by the United States Department of Commerce
and adopted by the Coffee Brewing Center of the Pan American Coffee Bureau. Adjustments may be made to
alter both the amount and grind from the factory setting.
Carefully read and follow all notices on the grinder and in this manual. They were written for your protection.
All notices on the grinder are to be kept in good condition. Replace any unreadable or damaged labels.
PERSONAL INJURY
HAZARD.
KEEP FINGERS AND
FOREIGN OBJECTS
OUT OF HOPPER
OR CHUTE OPENING.
05876.0000
37881.0000
This grinder has an attached cordset and requires:
2-wire, grounded service rated 120 volts ac, 9 amp, single phase, 60 Hz for 120 volt models,
2-wire, grounded service rated 230 volts ac, 4 amp, single phase, 50 Hz for 230 volt models,
2-wire, grounded service rated 100 volts ac, 9 amp, single phase, 50 Hz for 100 volt models.
NOTE: If the power cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly
qualified person in order to avoid a hazard.
INTRODUCTION

USER NOTICES

ELECTRICAL REQUIREMENTS

3
WARNING
Use only on a properly protected circuit
capable of the rated load.
Electrically ground the chassis.
Follow national/local electrical codes.
Do not use near combustibles.
An extension cord, when used, must be shorter
than 20 feet if 16-gage 3-conductor wire, or
shorter than 10 feet if 18-gage 3-conductor wire.
FAILURE TO COMPLY RISKS EQUIPMENT
DAMAGE, FIRE, OR SHOCK HAZARD
READ THE ENTIRE OPERATING MANUAL
INCLUDING THE LIMIT OF WARRANTY AND
LIABILITY BEFORE BUYING OR USING THIS PRODUCT
20545-0000D 01/04 © 1990 Bunn-O-Matic Corporation
20545.0000
33736 030205

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents