Container; Motor Box - Husqvarna S 13 Workshop Manual

• To clean the prefilter with jet pulse cleaning kit, do
these steps:
a) Start the product.
b) Close the inlet valve to seal the inlet.
c) Wait for 5 seconds for the product to make a
vacuum.
d) Push and hold the arm to the jet pulse cleaning
kit for 5 seconds.
e) Wait for 5 seconds again, and then push and
hold the arm to the jet pulse cleaning kit for 5
seconds. Do this step again and again until you
have pushed the jet pulse cleaning kit 5 times.
• Replace the prefilter if the suction does not become
better when you clean the prefilter. Refer to
replace the prefilter on page 18 .

8.4 Container

8.4.1 To remove the container
1. Remove the top cover. Refer to
cover on page 17 .
2. Remove the prefilter. Refer to
prefilter on page 18 .
3. Remove the Longopac dust bag.
4. Loosen the screws that hold the container to the
frame.
5. Remove the container from the frame.
8.4.2 To clean and examine the container
1. Examine the container for damage.
2. Make sure that the bottom lid opens and closes
correctly.
3. Remove dust from the container with a moist cloth.
4. Replace decals that are damaged.
8.4.3 To install the container
• Install the container in the opposite sequence to
remove the container on page 19 .
1347 - 001 -
To
To remove the top
To replace the
To

8.5 Motor box

8.5.1 To disconnect the circuit board (S 13)
1. Remove the HEPA filter, refer to
HEPA filter on page 17 .
2. Remove the motor tube gasket.
3. Remove the 8 screws and remove the motor
housing.
To replace the
Repair instructions - 19