Husqvarna S 13 Workshop Manual page 26

13. Use a flat screwdriver and a hammer to carefully
remove the soft start unit (A). If a rivet attaches the
soft start unit to the frame, drill the rivet off.
A
14. Loosen the nut below the electronic filter and
remove the electronic filter (B).
8.5.6 To install the soft start unit and the electronic
filter (S 36)
1. Attach the cables to the electronic filter and soft start
unit. Make sure that you attach the correct cable to
the correct position on the electronic filter. Refer to
Diagrams on page 28 .
C
A
B
26 - Repair instructions
B
D
Position
A
B
C
D
Ground
2. Attach the soft start unit to the frame with a rivet or a
small screw and a locknut.
3. Attach the new electronic filter to the frame with a
washer and a nut. Tighten the nut fully.
4. Assemble the product in the opposite sequence to
how it was disassembled, refer to
soft start unit and the electronic filter (S 36) on page
24 .
Cable color
Brown, ON/OFF switch
Brown, soft start unit
Blue, ON/OFF switch
Blue, 2 cables
Yellow/green, ground ca-
ble
To remove the
1347 - 001 -