Remote Control Lever Friction; Trim Tab Adjustment - TOHATSU MFS 6BZ Owner's Manual

ENOM00075-0
3. Remote control lever
friction
EP, EPT type
ENOW00074-C
WARNING
Do not over tighten the remote control
throttle friction adjustment screw or it
could result in difficult y of movement
resulting in the loss of control causing an
accident and could lead to severe injury.
To adjust the friction of the remote con-
trol lever, turn the throttle friction
adjustment screw on the front of the
remote control. Turn c lock wise to
increase the friction and counter-clock-
wise to decrease it.
Side mount type
2
1
1. Throttle friction adjustment screw
2. Decrease
3. Increase
3
ENOF00078-2
ENOM00076-0

4. Trim tab adjustment

ENOW00076-1
WARNING
Be sure that outboard motor is secured to
transom or service stand, or accidental
drop or fall of outboard motor could lead
to severe personal injury.
Be sure to lock outboard motor when it is
tilted up, otherwise accidental fall of out-
board motor could lead to severe per-
sonal injury.
Do not go under outboard motor tilted up
and locked, or accidental fall of outboard
motor could lead to severe personal
injury.
ENOW00075-1
WARNING
Inappropriate adjustment of trim tab could
cause steering difficulty. After installing or
readjusting trim tab, check if steering load is
even.
If straight-line cruising can not be
achieved, adjust the trim tab located
under the anti-ventilation plate.
If the boat veers toward the left direct
the trim tab towards A (left from rear
of boat).
If the boat veers toward the right
direct the trim tab towards B (right
from rear of boat).
59
ADJUSTMENT
9