Advertisement
Wiring
L1 L2 L3
Jumpers
Temperature sensor bts 01
• 1x RJ 11 black flat cable
Communication
• 2x RJ 45 black flat cable :
rcc 02/03 / multi-units :
xtender, vt, vs, bsp, xcom
EN
The device must be installed in accordance with local standards and regulations in force.
FR
L'appareil doit être installé conformément aux normes et réglementations locales en vigueur.
DE
Das Gerät muss gemäß den geltenden örtlichen Normen und Vorschriften installiert werden.
El dispositivo debe instalarse de acuerdo con las normas y regulaciones locales vigentes.
ES
8
Auxiliary Contacts
AUX1
AUX2
L1 L2 L3
L
N
Remote control rcm 10
• 1x RJ 11 black flat cable
Bus termination
*Bat+ connection
(provided)
NC C NO
L
N
M8
Battery connection
• 70mm
cable M8, 10Nm
2
fusible
• 50mm
cable M8, 10Nm
2
ceramic
washer
• 35mm
cable M8, 10Nm
2
washer
bolt
Protection device (battery side)*
M8 x 30
• 150A
xtm 2600-48
M10 cable
• 250A
xtm 1500-12
*Internal fuse provided on bat+, recommended external fuse
AC out connection
AC in connection
• Up to 3x10mm
• Up to 3x10mm
cable, 1.6Nm
2
Protection device to protect cables
Up to 56Aac, circuit breaker type B
Protection device AC
Protection device to protect people
50Aac, circuit breaker type B
Up to 56Aac, RCCB/RCD, check
Overvoltage protection, SPD
earth scheme
Overvoltage protection, SPD
T10
BAT+, M8
xtm 1500-12
xtm 2000-12
xtm 3500-24
xtm 2400-24
xtm 4000-48
BAT-, M10
xtm 2600-48
/ 200A
xtm 2400-24
xtm 4000-48
/ 300A
xtm 2000-12
xtm 3500-24
Lithium batteries
communication
BMS CAN
CAN
Li
xcom CAN
cable, 1.6Nm
2
* Check
xcom CAN
manual
9
Advertisement
