Chapter 15 - Antennas, Cables, Gps; Antenna System Cellular Devices; Notice Regarding Compliance With Fcc, Eu, And Industry Canada Requirements For Rf Exposure; Ev-Do And Cdma Antenna Information - Multitech MultiConnect MTPCIE-EV3 Developer's Manual

Table of Contents

Chapter 15 – Antennas, Cables, GPS

The cellular/wireless performance depends on the implementation and antenna design. The integration of the

antenna system into the product is a critical part of the design process; therefore, it is essential to consider it early

so the performance is not compromised. If changes are made to the device's certified antenna system, then

recertification will be required by specific network carriers.

Notice regarding Compliance with FCC, EU, and Industry Canada Requirements for RF

Exposure

The antenna intended for use with this unit meets the requirements for mobile operating configurations and for

fixed mounted operations, as defined in 2.1091 of the FCC rules for satisfying RF exposure compliance. This device

also meets the European RF exposure requirements of EN 62311. If an alternate antenna is used, consult user

documentation for required antenna specifications.

Compliance of the device with the FCC, EU and IC rules regarding RF Exposure was established and is given with

the maximum antenna gain as specified above for a minimum distance of 20 cm between the devices radiating

structures (the antenna) and the body of users. Qualification for distances closer than 20 cm (portable operation)

would require re-certification.

Wireless devices could generate radiation. Other nearby electronic devices, like microwave ovens, may also

generate additional radiation to the user causing a higher level of RF exposure.

EV-DO and CDMA Authorized Antennas

These devices were approved with the following antenna:

Manufacturer:

Manufacturer's Model Number:

MultiTech Part Number

Multi-Tech ordering information:

Model

ANQB-1HRA

ANQB-10HRA

ANQB-50HRA

EV-DO and CDMA Antenna Requirements

Need help?

Do you have a question about the MultiConnect MTPCIE-EV3 and is the answer not in the manual?