Advertisement
Lumination
(LRX - Series)
®
Lumens Setting Switch
NOTE: Forr 1000/650lm product, default output lumen is 1000lm. Push switch up or left to activate 650lm. For 4000/3000lm product, default
output level is 4000lm.
6" and 8"
6" and 8"
6" and 8"
6" and 8"
Remove nut from
Remove nut from
Remove nut from
test switch
Remove nut from
test switch
test switch
test switch
7
Attach the test switch to the LRX EMBB fixture or junction box. If the fixture is 6" or 8", first remove the nut from the end of test switch,
and put test switch through the hole of fixture, then thread nut to test switch. If the fixture is 4", mount to the junction box and provided
flexible conduit for remote mounting of the test switch.
NOTE: For phase cut dimming product, dimming leads (violet and gray wires) are disconnected.
8
Connect the quick connector of LRX EMBB fixture and LRXEMBBKIT07( or LRXEMBBKIT07HE, or LRXEMBBKIT10)
and close quick connector box well.
NOTE: For phase cut dimming product, dimming leads (violet and gray wires) are open.
6" and 8"
6" and 8"
6" and 8"
6" and 8"
Attach to housing
Attach to housing
Attach to housing
Attach to housing
6" and 8"
6" and 8"
6" and 8"
6" and 8"
Tighten nut on
Tighten nut on
Tighten nut on
inside of housing
Tighten nut on
inside of housing
inside of housing
inside of housing
5
Installation Guide
4"
4"
4"
4"
Box closed
Box closed
Advertisement
