Advertisement
Quick Links
UltraMax®
Connected LED Driver (GE80MCC/Z2P1500)
BEFORE YOU BEGIN
Read these instructions completely and carefully.
RISK OF ELECTRIC SHOCK
•
Turn power off before inspection, installation, or removal.
•
Properly ground electrical enclosure.
RISK OF FIRE
•
Follow all NEC and local codes
•
Use only UL-approved wire for input/output connections.
•
Minimum size 14 AWG for continuous runs.
Save These Instructions
Use only in the manner intended by the manufacturer.
If you have any questions, contact the manufacturer.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
CAN ICES-005(A)/NMB-005(A)
Note: This equipment has been tested and found to comply with the
limits for a Class A digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area
is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
WARNING / AVERTISSEMENT
RISQUES DE DÉCHARGES ÉLECTRIQUES
Coupe l'alimentation avant d'inspecter, installer ou déplacer le luminaire.
Assurez-vous de correctement mettre à la terre le boitier d'alimentation
électrique
RISQUES D'INCENDIE
Respectez tous les codes NEC et codes locaux.
N'utilisez que des fils approuvés par UL pour les entrees / sorties de
connexion. Taille minimum 14 AWG.
Prepare Electrical Wiring
Electrical Requirements
• The LED driver must be connected to the mains
supply according to its ratings on the product label.
• Class 1 wiring should be in accordance with NEC.
Grounding Instructions
• The grounding and bonding of the overall system
shall be done in accordance to local electric code
of the country where the luminaire is installed.
Installation Guide
XXXXXX | A-XXXXX
Advertisement
Related Manuals for Daintree GE Current UltraMax GED80MCC/Z2P1500
Summary of Contents for Daintree GE Current UltraMax GED80MCC/Z2P1500
- Page 1 Installation Guide XXXXXX | A-XXXXX UltraMax® Connected LED Driver (GE80MCC/Z2P1500) BEFORE YOU BEGIN Read these instructions completely and carefully. WARNING / AVERTISSEMENT RISK OF ELECTRIC SHOCK RISQUES DE DÉCHARGES ÉLECTRIQUES • Turn power off before inspection, installation, or removal. Coupe l’alimentation avant d’inspecter, installer ou déplacer le luminaire. •...
- Page 2 UltraMax® Connected LED Driver (GED80MCC/Z2P1500) Installation Guide Before installing this driver: 1. Remove power from LED luminaire by switching circuit breaker powering the LED luminaire to the off position. CAUTION: Turning off the LED luminaire’s wall switch may not remove voltage from the LED luminaire. 2.
- Page 3 Product Title (XXX- Series) Installation Guide This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions: This device may not cause interference This device must accept any interference, including interference that may cause undesired operation of the device. L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts de licence.