Table of Contents
Advertisement
Ampere Rating
Not More
More Than
Than
0
6
6
10
10
12
12
16
Use the table above for your correct voltage.
For safety reasons, always wear protective gloves and goggles when using this product.
Do not drop or impact the product. Strong impacts may result in deformation or damage.
Do not modify or disassemble this product in any way that is not described in the instruction manual. This can
have a significant impact on performance and safety. If the controller is disassembled, you may receive an
electric shock due to the high voltage section inside. In the event of malfunction or repair, please contact the
place of purchase for repair.
Be sure to ground the grounding wire of the power cord before use. Failure to do so may result in a malfunction,
fire or electric shock.
Do not use this product in an unventilated room where there is a risk of explosion or near flammable materials. If
the tool is in contact with flammable materials for a long periods of time in an oscillating state, it may ignite.
Use the controller at room temperature in the range of 10 - 40°C (75 - 104ºF), with no condensation.
Condensation may cause a short circuit or an electric shock.
Avoid installing the controller in the vicinity of high temperature, high humidity, condensation, corrosive or
explosive gases, flammable gases, salt damage, and direct sunlight. Failure to do so may result in a malfunction,
fire or electric shock.
The bottom of the controller also serves as a heat sink. Install it so that the space between it and the work desk
is not blocked. A temperature increase can occur inside the controller, causing failure.
If there is any dust or damage to the threaded part of the blade holder, handpiece, or blade mountings, normal
oscillation will not be possible. It can also cause the handpiece to heat up. In addition,the handpiece maygenerate
heat,so be sure to remove any dust before use.
Make sure the blade is securely installed. If it is not secured firmly, it will cause a loss of power and heat in the
handpiece.
Do not touch the blade or horn during ultrasonic vibration or immediately after the output stops. The blade and
horn parts may become hot and may cause injury or burns.
If oil or other contaminants get into the handpiece, it may cause a malfunction. Do not lubricate the handpiece.
Damaged main power cord must be replaced with new cord as they may cause fires or electric shock due to a
short circuit. Please contact us or your local distributor for details.
When shipped, the handpiece comes with a blade attached. Remove the cap to avoid touching the blade and
causing injury.
If the blade is over-tightened or cracked, turning the ON / OFF key to "ON" may cause the blade to break off and
fall out oftheholder.
Volts
120V
7.5m (25ft.)
240V
15m (50ft.)
18
18
16
14
WARNING
23
Safety Precautions
Total length of cord
15m (50ft.)
30m (100ft.)
30m (100ft.)
60m (200ft.)
16
16
16
14
16
14
12
Not Recommended
45m (150ft.)
90m (300ft.)
14
12
12
Advertisement
Table of Contents
