Table of Contents
Advertisement
9 – 3
Protection Circuitry
Protection Features
30W or more in detected, the unit will stop operating for safety. (see "7 – 1 Error code"03")
If the handpiece is pulled out of the connector during operation, it will stop.
To prevent the handpiece from forgetting to turn it off, the handpiece will stop automatically if it is still
unused when it is on. (see "7 – 1 Error code"13") (Time to stop can be changed by user settings. It
can also be disabled. see "6 – 2 Setting the forced stop time when not in use")
If the main power switch is turned on while stepping on the foot switch, it will be disabled for safety reasons.
Release the foot switch because the indicator on the operation panel blinks and a notification sounds. The drive
prohibit state is lifted and the unit can be used normally.
If a handpiece temperature rise is detected from the output power, or if the blade is found to be
generatingexcessive heat, the handpiece heat protection function is activated, the display on the control panel
flashes andan audible alarm will sound.
After that, it automatically suppresses the output and keeps the temperature from rising, allowing for continuous
use. When the temperature drops, the indicator on the control panel stop blinking and the notification sound is
automatically cancelled.
(You can also disable it through user settings. 6 – 6 Setting the handpiece heat protection function")
How to clear the error condition with the protection function
If the protection function is activated and the error is stopped, remove the cause of the activation of the
protection circuitry and then clear the error state by performing the following operations
Press the ON / OFF key or step on the foot switch again. The ERROR LED goes off and the error
state can be cleared.
9 – 4
Symbol
Note, see Operating Instructions
Conforms to European Directives
United Kingdom Conformity Assessed
Conforms to North American Safety Standards (UL, CSA)
Disposal of products and accessories in accordance with the EU Directive
on Waste Electrical and Electronic Equipment (WEEE) (2012/19/EU)
serial number
Caution, high temperature surface
CAUTION
41
Specifications
Advertisement
Table of Contents
