Setting The Foot Switch; Setting The Handpiece Heat Protection Function; Initializing Settings - Nakanishi Sonic Cutter ZERO Operation Manual

6 – 5

Setting the foot switch

The setting can be changed from pressing the foot switch to start (ON) or release to stop (OFF), to
pressing the foot switch to start (ON) or pressing it again to stop (OFF).
Press the DOWN key to change the setting value.
6 – 6

Setting the handpiece heat protection function

The heat protection function can be set to work if an abnormal heat is detected on the tip of the tool.
Press the DOWN key to change the setting value.
6 – 7

Initializing Settings

You can restore the factory default settings.
While pressing the UP key and the DOWN key (1) at the same time, turn ON the power switch (2).
Release the UP key and DOWN key after "beep" and a beep sounds to initialize the user settings.
When the power switch is turned OFF and then ON again, the output display is set to MIN and the unit
starts up in normal mode.
①
②
The Indicator shows the following order
" " " " " "
Motion operation (depressing the foot switch turns ON
and releasing the foot switch turns OFF) (factory default
setting)
Alternate operation (press the foot switch to start up,
press it again to stop off)
The Indicator shows the following order
" " " " " "
unprotected
Protected (default setting)
Factory Default Settings
Forced stop time when not
in use
Notification volume
Amplitude display and watt
display
Foot switch
handpiece heat protection
function
35
...
...
3 minutes.
Notification Sound Loud
Displayed in 0.1W
increments
Motion operation
(depressing the foot switch
turns ON and releasing it
turns OFF)
Protection Values
Setup