Advertisement
14
INSTALL #3 CROSSRIB.
•
Place Crossrib directly above the keel and chine bars
(forward of the seat sling) and push down.
•
Tilt the Crossrib back towards the Stern and engage the two
Gunwale bars.
•
Straighten the crossrib and slide forward until it is near the
spring buttons that protrude from the keel and chine
extension bars.
•
Rotate the keel and chine extension bars until the screws
that protrude from the crossrib align with the holes in the
black plastic blocks.
Note: (The lever bar can be used to help rotate tubes.
Calf Plates
Insert pin into hole used when you extended the frame.
Rotate to align.)
•
Rotate the two gunwale extension bars until the black blocks
attached to them face towards the middle of the cockpit.
•
Depress one of the gunwale spring buttons and slide the
crossrib over it. Do the same with the chine and keel bars
and then the other gunwale and chine bars.
CALF PLATES
•
Install the plastic plate supports by wrapping Velcro
around Crossrib #3.
Feathercraft
Khatsalano
13
Advertisement
