Table of Contents
Advertisement
A6V10315040_b_en_--
X3
Connector for operating unit via ribbon cable
X15
Connector for power supply output Vsys
X16
Connector for supply input Vsys 2
X17
Connector for supply input Vsys 1
X400
Connector for the periphery bus (for options)
1. Install the fire terminal board (2) on the back box using the four fixing screws (3).
2. Use the ribbon cable supplied with the operating unit to connect operating unit to
X3.
3. When connecting supplies, make sure no AC is applied. Connect power supply to
X5 Vsys input. If redundancy is needed, also connect power supply to X6 Vsys2
input.
4. Only apply AC after wiring is complete.
Fire terminal board FTI2001
Installation
1
7 | 14
Advertisement
Table of Contents
