ZyXEL Communications NBG6515 User Manual page 68

Network > Wireless LAN 5G > AP Select
Fig ure 52
The following table describes the labels in this screen.
Table 33 Network > Wireless LAN 5G > AP Select
L ABEL DESC RIPT IO N
NO. This is the index number of the APs.
Select Use the radio button to select the WiFi device to which you want to connect.
SSID This displays the Service Set IDentity of the WiFi device. The SSID is a unique name that
identifies a WiFi network. All devices in a WiFi network must use the same SSID.
MAC This displays the MAC address of the WiFi device.
Channel This displays the channel number used by this WiFi device.
Mode This displays which IEEE 802.11b/g/n WiFi networking standards the WiFi device supports.
Security Mode This displays the type of security configured on the WiFi device. When
security is configured and you can connect to it without a password.
Strength This displays the strength of the WiFi signal. The signal strength mainly depends on the
antenna output power and the distance between your NBG and this device.
RSSI This shows the received signal strength indicator (RSSI), that is, the received signal strength in
dBm.
Setup repeater Select this to setup the AP manually.
manually
SSID If
Se tup re pe a te r m a nua lly
when the AP's SSID is hidden.
WPS Click
synchronization.
Refresh Click this to search for available WiFi devices within transmission range and update this table.
Next Click this to continue.
After you selected one of APs and click the
Chapter 9 Universal Repeater Mode
is selected, use this field to type the SSID of the AP. This is useful
to start WPS-aware WiFi station scanning and the WiFi security information
WPS
Ne xt
NBG6515 User's Guide
68
button, the screen will display as below.
is shown, no
No Se c urity