Brother P-touch PT-2200 User Manual page 82

Error Message
NO
TAPE!
NUMBER
TOO SMALL!
REPLACE
BATTERIES!
ROM
PROBLEM!
SYSTEM
ERROR!
TAB
LIMIT!
TEXT
TOO HIGH!
TEXT
TOO LONG!
78
Cause
• This message appears if you try
to print a label or feed the tape
when no tape cassette is
installed.
• This message appears if the
number that is set to be
printed using the Numbering
function is less than the
number above the cursor.
• This message appears if the
installed alkaline batteries are
about to run out.
• This message appears if there
is a problem with the
machine's read only memory.
• This message appears if there
is a problem with the
machine's software.
• This message appears if 50 tabs
have already been added to the
text when you press
• This message appears if the
size of the text is larger than
the width of the installed tape.
• This message appears if the
length of the text is longer
than the label length that has
been set using the Length
function.
• Install a tape cassette and try
again.
• Press the key of a number that
is greater than the number in
the text.
• Replace the batteries or use
the AC adaptor.
• Contact your service repre-
sentative.
Turn off the machine, and
then while holding down
machine back on.
• Contact your service repre-
sentative.
• Limit the number of tabs in
the text to 50.
Tab
.
• Reduce the size of the charac-
ters or install a wider tape.
• Delete some of the text,
reduce the character width or
increase the set label length.
Remedy
Align
and , turn the