Brother P-touch PT-2200 User Manual page 49

Mirror
4
Press to engrave the stamp stencil film, and then automatically cut off.
To affix a stamp:
5
Remove the stamp frame from around the stamp film holder ink pad, one side at a
time, then remove the protective seal covering the ink pad and the backing paper
from the stamp stencil film.
6
With the glossy side of the stamp stencil film upward, align one of its ends with the
slit on the side of the stamp film holder.
7
Hold the end of the stamp stencil film in place with your thumb, then pass the tape
through the guides while pulling it tight.
Glossy side
Tape end
Slit
Guides
Alt C O P I E S
1 / 1
Caps
Length
Undl/Frm
Wide
45