Xylem Bell & Gossett Autocirc e3-4 Series Installation, Operation And Maintenance Manual page 26

en – Original Instructions
1. Loosen the screw ring before installation.
2. Rotate the pump motor to the required installation position.
3. Tighten the screw ring.
When installing the recirculating pump in a horizontal position, the timer shall point upwards. It
may be turned in the range from 10:30 to 13:30 (±45°) at maximum, in order to maintain the
ingress protection class (see Figure 13 on page 26).
Rotating the pump motor (vertical installation)
Figure 12
Rotating the pump motor (horizontal installation)
Figure 13
26 Installation, Operation and Maintenance Manual