Restoring The Network Settings To Factory Default - Brother HL-4050CDN Network User's Manual
Multi-protocol on-board ethernet print server and wireless (ieee 802.11b/g) ethernet print server
Hide thumbs
Also See for HL-4050CDN:
- User manual (211 pages) ,
- Technical reference manual (517 pages) ,
- Service manual (341 pages)
Table of Contents
Advertisement
Restoring the network settings to factory default
If you wish to reset the print server back to its default factory settings (resetting all information such as the
password and IP address information), please follow these steps:
a
Make sure that the power cord is plugged in.
b
Turn on the printer and wait until the printer is in the Ready state.
c
Press any of the Menu buttons (+, -, OK or Back) of the control panel on your printer to take the printer
off-line.
d
Press the + or - button to choose LAN. Press OK.
e
Press the + or - button to choose Factory Reset. Press OK.
f
Press OK again.
Note
You can reset the print server back to its default factory settings using the BRAdmin application or Web
Based Management (web browser). For more information, see Changing the print server
settings on page 15.
Control panel setup
10
10
117
Advertisement
Table of Contents
Troubleshooting
