Reloading Process - Brother HL-2700CN Network User's Manual

Reloading Process

The Data LED on the printer control panel will blink during the
firmware file loading process. During programming process, the
backlight on the printer's LCD goes off, and Erase xxxxxx and Write
xxxxxx will be indicated alternately on the LCD. After the firmware
update is completed, the printer will re-start automatically. DO NOT
TURN OFF THE PRINTER DURING THESE PROCESSES.
If the Data LED does not stop blinking after about two minutes, check
to make sure that you correctly entered all parameters and that your
network connections are good. Then power the print server/printer
off and then on again, to retry the download.
If you encounter problems upgrading the firmware and you
find that the network portion of the printer no longer functions,
you should try re-programming the print server by using the
COPY command from the DOS prompt of your PC. To do
this, connect a parallel cable between your PC and printer
and use the command COPY filename LPT1:/B (where
filename is the new firmware file).
APPENDIX A - 6