Brother HL-2700CN Network User's Manual page 80

b
Select the Brother print server from the list of print servers.
When you get the message that the print server is connected,
press the ENTER key and type the default password access
in response to the # prompt (the password will not echo) and
then press the ENTER key again in response to the Enter
Username> prompt. When you get the Local> prompt, type:
SET NETWARE NPRINTER nlm number ON service
SET NETWARE RESCAN
EXIT
Where nlm is the name of the PSERVER NLM on your file
server.
Number is the printer number (this must match the printer
number you selected during the PCONSOLE configuration
in the previous steps).
Service is the name of the service assigned by NetWare
print server name (where the default services are
BRN_xxxxxx_P1 for the Brother printer, where xxxxxx is
the last six digits of the Ethernet address (MAC address)).
For example, to set up remote "Printer 3" for a Brother printer with
the print server BRN_310107_P1 using the PSERVER NLM called
BROTHER1PS, you would type:
SET NETWARE NPRINTER BROTHER1PS 3 ON BRN_310107_P1
SET NETWARE RESCAN
EXIT
You can also enter the remote printer name using your web
browser, by connecting to the Brother print server using the TCP/
IP protocol and selecting the NetWare protocol configuration.
The same services assigned by NetWare print server name
cannot be used for both queue server mode and remote
printer mode.
You must now unload the PSERVER NLM from your
NetWare file server console and then reload it in order for the
changes to take effect.
6 - 21 NOVELL NETWARE PRINTING