Fully Programmed Bending - Greenlee 855GX Instruction Manual

Operation (cont'd)

Fully Programmed Bending

The computer can also be used to help lay out bends.
1. Press the button next to "PROG BEND" to start
programming a bend.
Note: Press the home button
return to the home screen shown above.
2. Press the button next to the type of conduit dis-
played in the LCD display that you will be using; or
press the button next to "LOAD FILE" to retrieve a
saved bend from a USB thumb drive. Press NEXT
to proceed or BACK to return to the previous
screen.
Greenlee / A Textron Company
Find Quality Products Online at:
SELECT ANGLE
OR FUNCTION
at any time to
GlobalTestSupply
www.
855GX Electric Bender
3. Press the button next to the size of conduit dis-
played in the LCD display that you will be using.
Press NEXT to proceed or BACK to return to the
previous screen.
Note: "1/2" and "3/4" are displayed only when
"PVC RIG" conduit type is selected in step 2.
4. Press the button next to the type of bend that you
are going to make.
a. Select "STUB/KICK" for stubs or kicks.
b. Selecting "OFFSET" and NEXT will display
a new window from which you can choose
whether you want the length to be from the end
of the conduit to the start of the first bend or to
the end of the second bend.
c. Selecting "SADDLE" and NEXT will display
a new window from which you can choose a
three-bend or four-bend saddle.
d. Select "U-BEND" for back-to-back 90° U-bends.
5. Press NEXT to proceed or BACK to return to the
previous screen.
13
.com
sales@GlobalTestSupply.com