Advertisement
TEST Switch
You can test the printer or print out the list of fonts with the TEST switch.
To do so, hold down the SHIFT switch and press the TEST switch. You will
then enter the test mode where you may test the printer or print out the list of
fonts.
To test the printer, follow these steps:
1. Press the SEL switch to set the printer off-line.
2. Hold down the SHIFT switch and press the TEST switch.
When you enter the test mode, the display shows the first test mode item.
3. Press the
display.
DEMO PAGE
or
switch until the desired test mode appears on the
Display Message
DEMO PAGE
TEST PRINT
PRINT CONFIG
PRINT FONTS I
PRINT FONTS C
PRINT FONTS P
exit
CHAPTER 4 CONTROL PANEL
Test Mode
Prints out the demonstration.
Performs the printer test and prints
out the test pattern.
Prints out the list of panel switch
settings you have configured for the
printer as user settings.
Prints out the list of internal or
resident fonts.
Prints out the list of optional fonts
stored in the font cartridge/card.
Prints out the list of permanent
download fonts.
Exits from the test mode. The
printer does not perform the test.
4–85
Advertisement
