Advertisement
6. Press the
7. Press the SET switch.
Then the printer automatically returns to the off-line ready state.
INTERFACE MODE
The automatic interface selection has been factory set. If you want to select
a specific interface manually, use the interface mode to set it.
Display Message
I/F=PARALLEL
I/F=RS-232C
I/F=OPTION
I/F=AUTO
Select the setting menu and enter the sub-setting menu to change the setting
as follows:
Automatic Interface Selection
When you use the automatic interface selection function, select the function
on the display as follows:
When you select this function with the SET switch, the display shows the
next sub-setting menu as follows:
You need to set the time out for the auto interface selection from 1 to 99
seconds with the
out is the duration during which the printer will not allow another automatic
change to the interface.
or
switch until the exit menu appears on the display.
exit MODE
Interface Mode
Parallel interface
Serial interface
Optional interface for MIO card
Auto interface selection
I/F=AUTO
TIME OUT= 5s
or
switch: factory setting = 5 seconds. This time
CHAPTER 4 CONTROL PANEL
*
4–17
Advertisement
