Advertisement
Display Message
BaudRate= 9600
CodeType=8 bits
Parity
=NONE
Stop Bit=1 bits
Xon/Xoff=ON
DTR(ER) =ON
(Effective when
Xon/Xoff=ON)
Robust Xon =OFF
(Effective when
Xon/Xoff=ON)
Optional Interface
If you have installed a commercial modular input/output (MIO) card in the
printer, you can select the optional MIO interface in this mode. If the
installed MIO card requires any optional interface settings, they appear
under this menu. Set them, referring to the manual of the MIO card.
Note
This setting appears only when the MIO card has been installed. For
installation of the MIO card, see
Parameters
Baud rate
(Data transfer speed)
Code type
(Data length)
Parity
(Data error check)
Stop bits
(Data separator)
Xon/Xoff
(Handshake protocol)
Data terminal ready
(ER)
Robust Xon
I/F=OPTION
"MODULAR I/O CARD" in Chapter
CHAPTER 4 CONTROL PANEL
Settings
150, 300, 600, 1200, 2400, 4800,
9600, 19200, 38400, 57600, 115200
baud
7 bits or 8 bits
None, even, or odd
1 or 2
ON: DTR & Xon/Xoff handshake
OFF: DTR handshake only
ON: Makes DTR (ER) low when
the buffer is full.
OFF: Does not make DTR (ER)
low when the buffer is full.
DTR(ER) goes low only
when the printer is off-line.
ON:
Sends Xon while waiting.
OFF: Sends Xon once, when the
printer status changes from
off-line to on-line.
5.
4–19
Advertisement
