Relay Report; Setup Misc; Ethernet - Brother MFC-9420CN Network User's Manual

Multi-protocol on-board multi-function print server

Hide thumbs Also See for MFC-9420CN:

Table of Contents

Front Panel Setup

Relay Report

A Relay Broadcast Report can be printed at the machine that will act as a Relay Station for all Relay

Broadcasts. When the machine is used with the Brother Network PC Fax software the machine is also acting

as a Relay Station for fax transmissions from the network. This means that a Relay Report can also be printed

for confirmation of sent network faxes. (For US / Canada only)

Its primary function is to print reports of any relayed broadcasts that have been sent through the machine.

Please note: in order to use this function, you must assign the relay domain in the "Trusted Domains" section

of the Relay function settings.

Press Menu/Set,

Press ▲ or ▼ to select On or Off.

Press Menu/Set.

Press Stop/Exit.

Ethernet link mode. Auto allows the print server to operate in 100BASE-TX full or half duplex, or in 10BASE-T

full or half duplex mode.

100BASE-TX Full Duplex (100B-FD) or Half Duplex (100B-HD) and 10BASE-T Full Duplex (10B-FD) or Half

Duplex (10B-HD) fix the print server link mode. This change is valid after the print server has been reset

(default is Auto).

Note

If you incorrectly set this value, you may not be able to communicate with your print server.

Press Menu/Set, 6, 6, 1.

Press

to select Auto/100B-FD/100B-HD/10B-FD/10B-HD.

▲

▼

Press Menu/Set.

Press Stop/Exit.

3 - 14

Table of Contents